Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   ERA---Speak with Bob Putnam (http://www.clubcobra.com/forums/era-speak-bob-putnam/)
-   -   Mounting new Holley Fuel Pump in ERA (http://www.clubcobra.com/forums/era-speak-bob-putnam/105701-mounting-new-holley-fuel-pump-era.html)

Cobra 29 07-19-2010 06:34 PM
Mounting new Holley Fuel Pump in ERA
 
Bob, any advice on mounting a new georotor fuel pump from Holley HP 125? I believe the new pump is a little heavier than the old electric pump. Should I mount two alumimum plates to either side of the fibergrass trunk side panel first?

I plan to install the Fram HPG filter between the tank and the pump and a pump relay to ensure full battery voltage to the pump.

Thanks

strictlypersonl 07-20-2010 04:13 AM
Large OD washers would do the job too.

We usually mount the pump directly to the side of the frame rail with threaded inserts.

Cobra 29 07-20-2010 07:33 PM
Threaded inserts??
 
Bob, I have not used threaded inserts. What are these and how difficult are these to install?

Thanks

strictlypersonl 07-21-2010 04:00 AM
There are insert installation instructions in the manual in the bumper installation section for "Retrofitting the front nudge bar". I'd recommend using something like McMaster Carr's part # 98560A571.

PANAVIA 07-22-2010 10:04 PM
Threaded inserts are the way to go, --get the tool to install them properly and pay close attention to drill size and angle.


All times are GMT -7. The time now is 05:59 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: