Club Cobra

Club Cobra (
-   ERA---Speak with Bob Putnam (
-   -   rod ends (

John 550 09-05-2001 06:48 PM

rod ends
Hi Bob , Could you tell me what size rod ends I need for the rear trailing arms and what thread ( LH RH ) . Any suggestions for getting the old ones loose . I have a bad one on the passenger side . I noticed that Jegs sells high strength chrome moly thru hardened heat treated rolled threads permanently bonded teflon lining ones , you think there any good ?

Bob Putnam 09-06-2001 04:19 AM


It's a 5/8" RH-thread joint that we sleeve on the ball end to 1/2" ID. I'll just send you another one. I don't think that you can get an off-the-shelf (lined) one that's 5/8" x 1/2".

John 550 09-07-2001 09:40 AM

Thank you Bob ( you made my day) !

All times are GMT -7. The time now is 09:34 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting For full policy documentation refer to the following link: