|
Master Cylinders
Hi All...I would like to replace one of my master cylinders. When I was installing the new brake switch upgrade, I noticed a very small leak/seepage from the smaller master.
Do I just contact Bob to purchase a replacement, or do you recommend another source so I do not have to keep bugging Bob. Thanks, Nick #2049 FIA |
Nick - I sent you a text. It's all in the manual.:)
For about $60 each I'd replace both while you are at it and are opening the system up. Good time to do the flexible lines front and back as well. |
My 782 uses Tilton master cylinders for brakes and clutch which you can buy through a lot of places - I bought one replacement through Summit Racing. The size is usually cast on the side of the body - 750 is 3/4 inch, 825 is 7/8 inch, etc. your car is a few years earlier than mine so I would check the back of the assembly manual to see what they used then.
|
Just replaced my whole system. The rod end seal was leaking ( dynamic seal OK )
CARiD...sells individual master cylinders without the additional parts in the kit that I found others selling....many additional parts not required. Tilton P/N's 74-750 and 74-875 Gates Transmission oil cooler hose...SAE J1019 3/8" Replaced the BMW reservoir with a like P/N Relocated the new reservoir a clamp width higher to get the clamps out of the cockpit and accessible from the engine bay. Added a hose clamp at the forward face of the footbox to insure no contact between pedals and hoses. ERA520 |
Thanks to all
|
| All times are GMT -7. The time now is 11:34 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: