Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   ERA---Speak with Bob Putnam (http://www.clubcobra.com/forums/era-speak-bob-putnam/)
-   -   ERA Build Questions Continue (http://www.clubcobra.com/forums/era-speak-bob-putnam/82342-era-build-questions-continue.html)

SSSammy 10-20-2007 04:46 PM

Temp Gauge Post Script
 
The joke is on me .. I began to remove the defective gauge so I could put the new gauge in that Bob sent. Took the sensor loose at the manifold, took the gauge loose at the dash and pulled on the tube. Oooops! The water gauge tube ran to the oil pan .. the oil temp tube was in the manifold :LOL: :LOL: Swapped them and they both work fine .. sorry Stewart Warner!

There were two of us building .. one working under the car and one on top. Got our wires crossed :JEKYLHYDE My fault .. the dash was wired by me and I shoulda double checked ...

Bob, I'll be returning your new gauge unmolested :D

Sam

SSSammy 11-03-2007 05:25 PM

Did I overfill the diffy?
 
During the pre-start checks, I stuck my finger in the differential and felt the oil level about an inch below the hole. I thought it was supposed to be filled to the hole, like the tranny. So I put some extra 80-90 in to top it off.

Now I'm leaking gear lube heavily from the pinion seal. It is running along the frame and into the cockpit, under the rear cover, slinging up to the top of the tunnel too.

Does this sound like simple overfill? Should I let a little of it out? Or does it sound like a bad pinion seal?

thanks,
Sam


All times are GMT -7. The time now is 03:43 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: