|
Cost- FE manual/flywheel cover ?
I did not use a flywheel cover on my last 428, but with my new side oiler, Ram aluminum flywheel & Ram twin disk clutch, QuickTime bell and either the Tremec 600 or a Keisler, I may want one.
What's the going rate for one in very good condition ? The one I've found is way,... too expensive at $90.00 :eek: |
You mean a block plate? The Quicktime bellhousing comes with one.
|
No, a flywheel cover, some call it a inspection cover.
http://i53.tinypic.com/35m1nnk.jpg http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWAX%3AIT |
The block plate is solid and will cover the entire front side of the bellhousing.
|
| All times are GMT -7. The time now is 09:02 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: