|
Rocker shaft oil holes up or down?
Hi all,
me FE rebuilt is done, the Cleveland is replaced, the FE is sitting in the engine compartment and i'm going to final adjustments but before I will forget them I have some short quesitions. 1. Can't find an old thread where the orientation of the small oil holes in the erson rocker shaft was discussed. In each rocker arm position there is a small oil hole in the shaft, has it to be up or down? 2. And by the way, 6 1/2 quarts is the capacity of the aluminum "Cobra" lettered oil pan for the FE sold by Tony Branda, should i overfill it? Greetings from Germany, Westcott |
Doesn't matter on the Ersons. I always put them down though...
|
| All times are GMT -7. The time now is 07:08 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: