|
cross ram intake
does anyone know anything about a cross ram dual four fe intake?
|
Look down a few posts at the "Got my crossram" post. Some info there to start with. G.
|
Hi
This matter was discussed on an other website some weeks ago. This site is The Ford FE Garage or TheFordFEGarage@groups.msn.com http://Groups.msn.com/TheFordFEGarage. Check it out under "General", there are some 1300 chat subjects on the message board. There are some discussions on the C/R int. |
Micky Thompson made the intake. It was an interesting piece which met with limited success. Mostly the advantage is longer primary runners without punching holes in the hood. You will find two of the rarest Cobras ever made sporting them, One was made for Bill Cosby and the very last Cobra made was for Carroll Shelby. They were dual paxton supercherged units making well over 600 hp.
|
From what I have seen and read,
There were two comapnies that made them, Mickey Thompson and I think Edelbrock. With the Mickey thompson, you need to modify the distributor, so it will fit, as there is interference with the #1 port runner. Edelbrock's version has a notch made in the #1 runner so you can run a standard distributor. I believe neither were good for top end hp, whether they didn't breath well, the runners were not right, or there were fuel distribution problems, but they look good. |
Sobrac,
My memory may be fading, but I thought the Bill Cosby Cobra had an inline 2-4 setup when it was written up in the C&D or R&T at the time. |
| All times are GMT -7. The time now is 04:10 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: