|
Tada.....
Dyno'd my 428FE Friday afternoon.
http://www.youtube.com/watch?v=qG5wAu3WUcQ http://www.youtube.com/watch?v=qb9FSKNQRJY It made 533hp @ 6500 and 472lb-ft @ 5400. Made 12 pulls to over 6500 without any problems. |
Very nice.:D
Sounds awesome!!!!! CB |
That first video, two rusty tail pipes sticking out the back of a building? Only 'real' motorheads could appreciate such a vid, (it was cool, great sound track). :LOL:
|
Excellent!
Really good numbers and it sounds great! Congrats! Larry |
Great job! That building has a mean idle!
|
Hey Brent,
Can you tell me exactly what kind of break-in procedure you went through, where you did it and what you did before you started cranking it up to the higher RPM's? The engine sounds really impressive, way to go. |
WOW! Pretty exciting 16 seconds, huh? Sounds great!
Thanks, Lowell |
Mark,
It was ran for about 30 minutes at about 2000 rpm. It's a roller cam, so no breakin was needed....just cranked it, started it, set the timing, and let her go. After the first 30 minutes, we shut it down and ran the valves, did maintenance, etc. Then we did several more 20-30 minute runs (basically heat cycles) with a little load on the engine. Next came a pull to 6000...and again we checked the valve lash, etc. Then we made about 10-11 more pulls at around 6500-6600 while playing with timing, jets, vac springs, dizzy bushings, etc. It was done by Performance Engineering in Cincinnati, OH. Great bunch of guys.....really hard workers and very knowledgeable. |
VERY sweet, blykins. Congratulations!
Dan |
| All times are GMT -7. The time now is 02:50 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: