|
I'm sure this has been asked before
I'm sure this has been asked before but here goes again.
I've got a 428 FE and am going to do some changes this winter. When I put it back together I'd like to find a valve cover gasket that's an improvement on the standard cork units. My heads are fitted with studs for the valve covers and I use nyloc nuts to secure the covers but, other than my calibrated wrist, there isn't any way to insure I have even pressure on all of the nuts. Does anyone know of a gasket for the FE's with inserts for the nuts that can be torqued to a specific value to insure even tightening when they're installed? I know them make them for the small blocks and other engines but I was wondering about the FE's. Thanks for your input. DonC |
| All times are GMT -7. The time now is 06:55 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: