|
ignition wire looms for lemans covers
i am looking for the correct wire looms to use on my 427 fe, the covers i have are ford cast alum and say cobra/le mans on them, on the center of the covers is a stand to hold a wire loom, where can i purchase these looms to route my wires up and over on my csx4000 #15, thanks, jeff
|
Jeff,
I bought a set of these looms when I purchased other items from Finishline (www.cobraaccessories.com) they were reasonable, plus I needed other stuff from Enzo (The Owner) anyway. Lots of luck Chris |
I bought a set of two, three and four hole guides and mocked up my own clips to fit the Le Mans covers. The guides can move/swivel freely on the "clip" while still being held firmly in place.
http://www.clubcobra.com/photopost/d...tor_pics05.JPG |
wire separators for Lemans valve cover.
Finish Line sells the exact part, called a "Wire Separator for Valve Covers." Cost is $6.00 each in my catalog. Snaps right in place on the Cobra Lemans case valve cover. Quick, easy and right.
|
wire separators for Lemans valve cover.
[IMG]http://www.clubcobra.com/photopost/d...4_2006_016.jpg[/IMG]Finish Line sells the exact part, called a "Wire Separator for Valve Covers." Cost is $6.00 each in my catalog. Snaps right in place on the Cobra Lemans case valve cover. Quick, easy and right.
|
Any vendor for 60's Mustang stuff sells these. Same as on 289. Standard fare for most all 60's Ford V8's. The current 8mm Helicore MSD type wires will fit in the "old" 7mm clips. I also think there are some 8mm clips too, but may not be readily available.
|
I picked up several of them up at a salvage yard for a few dollars.
|
On the bigger wire sets (9mm) some careful drilling and a few machine screws and you can mount the Ford Racing wire separator to the cover:
http://www.vintage-motorsports.com/a.../afh.sized.jpg |
| All times are GMT -7. The time now is 04:18 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: