Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   Fuel Injection & Tuning (http://www.clubcobra.com/forums/fuel-injection-tuning/)
-   -   Idle Air Control Location (http://www.clubcobra.com/forums/fuel-injection-tuning/91089-idle-air-control-location.html)

LodiWino 09-08-2008 07:41 AM

Idle Air Control Location
 
Where do you locate the idle air control air source on a stack injection intake manifold? Is one source adequate, or do you have to source all eight runner tubes?

thorconstr 09-08-2008 08:43 AM

Here's where we mount our IAC, the source is the plenum.
http://www.clubcobra.com/forums/atta...2&d=1203702984

thormotorsports1@msn.com
www.thormotorsports1.com

fkemmerer 09-08-2008 09:52 AM

Quote:

Originally Posted by LodiWino (Post 877419)
Where do you locate the idle air control air source on a stack injection intake manifold? Is one source adequate, or do you have to source all eight runner tubes?


What is typically done is to install plumbing under the intake. In this setup, a hardline is run from each point to a common reservoir under where the breather would go at the back of the intake. The IAC motor then attacheds to the common reservoir via the breather hole. Here's a picture of how this looks on my TWM intake.

Here's a picture of the hardline connections in the ports:

http://www.clubcobra.com/photopost/d...s_to_Ports.JPG

Here's a picture of the common reservoir at the back of the intake:

http://www.clubcobra.com/photopost/d...dium/IAC_2.JPG

And here's a picture of the IAC motor mounted on top of the intake:

http://www.clubcobra.com/photopost/d...C_Detail_1.JPG

Hope that this helps.


All times are GMT -7. The time now is 10:02 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: