![]() |
Anyone using mass flo?
Is anyone using mass flo fi system? My system is running rich and causing a stumbling problem. Don't know if it is the computer programing or if it is a bad sensor. Need a little input.
|
Stuart
Speak to the guys over on the www.ffcobra.com forum |
Stuart,
I am using MasFlow with out any problems. I did have to get it tuned on a chassis dyno to get rid of the rick condition when I first got the car on the road. Call Mass Flo they should be able to give you some options...Mac |
I have an older mass flow. Has your computer been chipped? Mine was not, and my fuel is not right anytime it is in open loop.
|
Is it a new install?
Keith Craft Plano had fits with mine until they discovered mechanic had installed distributor off timing, # 1 wire HAS to be on # 1 spot on distributor. Will run but has a Bad Stumble! |
If the mass air flow sensor and the injectors are sized to match, it should run sweet after about 5 starts and 10 minutes run each time (for EEC to "learn").
Assumptions: 1. EFI Distributor wiring as per flyboy1997 mentioned. 2. Stock Ford EEC as recommended by Chris at Mass Flo. 3. Grounds all installed. 4. Initial timing w spout out at 12-14 degrees 5. O2 sensors wired correctly. 6. Fuel pressure set at 38 PSI or as recommended for your injectors. 7. IAC installed and wired right. (Idle Air Control valve) |
| All times are GMT -7. The time now is 04:25 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: