Club Cobra

Club Cobra (
-   Inglese Induction Systems (
-   -   Idle trouble! (

BERNIE 07-01-2004 10:35 AM

Idle trouble!
Have IDA's on 302 enlarged to 51.5mm,air screws totally closed the engine run again (120 idle jet holder,65 jet)what do you think about this problem?,

Jessica Wysocki 07-08-2004 06:39 AM


Umm... your question is a little too complex for me.

E-mail our Inglese Sales Representative, Dan Miller, who builds & works on our systems at Inglese, and ask him directly. He will be able to answer any & all questions you have concerning WEBER Induction Systems.

Sorry for such a late reply, I have been away at the Model T Summer Nationals in Worcester Mass. and I just got back today.

If you have any other questions concerning Inglese or WEBER Induction Systems, just let me know.

All times are GMT -7. The time now is 10:25 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting For full policy documentation refer to the following link: