|
Rear Axle Brackets
I'm in the process of assembling the rear axle, and I've got a question about the 2 degree angle of the pinion.
According to the assembly manual, the angle is measured two degrees positive from the flat surface of the back of the 4-link brackets. However, when the rear is installed in the frame, the pinion angle is several degrees negative, which leads me to believe that the angle should actually be measured from the centerline of the bolt holes in the brackets, NOT the back of the brackets as implied by the manual. Any verification of this would be greatly appreciated! Thanks, Mark http://fastfords.net |
| All times are GMT -7. The time now is 03:09 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: