|
(Garage Sale) Brakes-fuel pump-etc.
Cleaning out garage and came across these parts: ALL parts are priced less shipping.
Like new 11" GM Metric front brakes with adaptors, calipers, rotors, and LN bearings for Mustang II front suspension. Used less than 500 miles. In addition to the LN stock brake pads I will also include a set of Porterfield RS4 pads with virtually no wear. Price $120.00 (the Porterfield pads were $90.00 alone). Dual remote alum oil filter housing $10.00 Red Holley fuel pump $40.00 Proformer shift light (less bracket) $10.00 New lower ball joint for Mustang II (4 bolt type) $10.00 2 New 18" lng braided AN-4 braided lines w/ banjo fittings $20.00 MSD Blaster Coil (used but good cond) $10.00 Any questions call or email at 918-633-5336 clharlan@duke-energy.com or tulsacobra@valornet.com |
Dibs on the 11" brakes (if they fit within 15" wheels)!
|
There yours Pete!
I am sending you a PM. Clois |
Clois!!!!!
Red Holley Fuel PUMP!!!!!!!!!!!!!!! Mine! Mine! MIne! Mail me. |
Red Holley fuel pump is sold!
Clois |
That s what I get fro not keeping a closer watch.
I will take the coil and the braided fittings if still available. Mark |
Mark the coil is yours but I am holding the ss braided lines until tomorrow so one of our members can check on his size requirements.
Send me your address in a PM and I will send it to you. If the lines become available do you want them too? Clois |
Clois,
You have email and yes, if the lines free up I would still like them. Mark |
Thanks Everyone-All Parts are now SOLD!!!
Clois |
Hey Clois, what sort of hose ends / hoses do I need (and where do I get them) to hook up the calipers to the hard lines? The calipers have a different thread than the standard Mustang II calipers.
thanks again! |
Pete,
Use AN 3 braided lines for your ends about 14" long. Also, you will need two (2) frame type brake fittings that will accept your 5/16" hard lines and a flared AN 3 end. Or, you can remove the fittings I left in the calipers and just replace them witht a metric type fitting that can be purchased from a parts house for about $3.00. Clois |
Thanks for the info!
|
| All times are GMT -7. The time now is 10:29 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: