Need exact 351 distributor spigot size.
After exploring different options with the block spigot issue I have come up with a fix, machine/grind the spigot down 0.030" make up an interference fit sleeve out of 4130 and either heat and slip over shaft or loctite and press on. The only downside is if replacing a gear the sleeve will need to be ground off.
I need the exact 351 distributor shaft size below the drive gear the ICE guy measured a worn shaft at 0.514.7" Jac Mac I am not sure about the 0.513" for block measurement and its probably very hard to measure the block, if the shafts are around 0.515" then I would assume the block would be more like 0.518" any info greatly appreciated. Quote:
|
All times are GMT -7. The time now is 05:51 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: