Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   Shop Talk (http://www.clubcobra.com/forums/shop-talk/)
-   -   Windshield Wiper mounting location measurements needed... (http://www.clubcobra.com/forums/shop-talk/20635-windshield-wiper-mounting-location-measurements-needed.html)

Mike Braddock 09-28-2002 08:43 AM

Windshield Wiper mounting location measurements needed...
 
We are preparing to install the windshield wiper kit we purchased from FinishLine but the location of the wiper boxes as per our manufacturer (Everette Morrison) seems to bias the drv's side about 6 inches. So I wanted to ask if any of you could make a quick measurement from the end(s) of your windshield to the approx. location of your wiper shafts. Also, approx how far away from the base of the windshield are the shafts? Finally, can anyone tell me how far these wipers move as they sweep across the windshield? Ie 110 degrees, etc. Thanks so much for your help!

Mike

niles 09-30-2002 02:27 PM

wipers
 
Mike:
On my hunter they are centered. 16 in between wipers.
They are located 3 in from the edge of the engine opening and also 3 in from the edge of the windshield.

gn

Mike Braddock 09-30-2002 02:58 PM

Thanks Niles. I mounted mine to a scrap piece of fiberglass I had and measured the swept angle to be 115 on low and 118 on high. Thanks again!

Mike

Jon Miller 09-30-2002 08:43 PM

Hi Mike,

I've got an E-M with factory drilled wiper holes at 20 3/4" O.C.

I don't have the windshield installed yet, but the distance back from the hood gap is 2 3/4" to the center hole and 3 3/4" to the driver side hole.

I can try to e-mail you a picture if that would help.....

-Jon


All times are GMT -7. The time now is 03:10 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: