|
looking for a tool
I'm looking for a tool to twist an eye into the end of a push pull cable as in a heater control valve cable. I was told it is a common tool but have not found any yet.
|
Most use a "Z" bend. Look at radio control sites these are used for servo rods. There is a little trick to getting a sharp bend and not breaking the wire.
|
There is a special tool for putting the "Z" bend on the wire.
Check with your local lawn mower shop, they use them all the time. I've used them before, they are small and fairly cheep, as tools go ! Mower shops use them for choke and throtle cables. Good luck...... Remember, measure twice, cut once !!:D |
| All times are GMT -7. The time now is 01:54 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: