|
flat spot
i have 44mm idf's on my engine with 50 idle jets and 150 mains
it has a flat spot around 2500rpm and my plugs are black as black how do i fix the flat spot and stop my plugs from fouling up? |
cal is probably the best to ask...not sure if IDF's have bypasses or not...but cal can answer that if he reads this one....you might want to repost with weber flat spot as a topic so it gets the weber peoples attention.
If IDF's have them what are you bypass valves set at...what are the idle holder size and what emulsion tubes are you running? The flat spot can be too lean or too rich...it sounds like you are running too rich but that could be caused by too much gas going into the cylinder. Cal chime in here.... Matt |
| All times are GMT -7. The time now is 05:15 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: