|
Dash Grommets
I'm looking for grommets that are located under the screws for mouting the dash. All of the Home Depot, Menards and Ace Hardware stores carry the stamped steel units, which look like they would cut into the dash fabric once you snug them up.
Does anyone have a source for solid units that would have a flat back? |
I used s/s finish washers and screws--the trick is to not use a powerdriver to run the screws in but to do it the old-fashioned way with a screwdriver so you can control the pressure--just run the screws in until they start to snug down and the washer doesn't spin--all the screws do is hold the dash in place, there is little stress on it so they don't have to be snugged down super tight. If you use a power driver you do run the risk of cutting the fabric or leather with the washer, unless you can control the driver speed and torque.
I've not seen any nice finish type washers with any flat back though there are rubber and plastic types available but they look more utilitarion(sp). |
Motorsports International carries solid brass chrome plated dash escutcheons as original. For authenticity, use nothing else.
Call Marge Guentzler at 619 390 9080. Bud:JEKYLHYDE :JEKYLHYDE :JEKYLHYDE |
I used the SS finish washers and glued them to a flat SS washer that was just slightly larger .that way I had the area of the flatwasher against the fabric.
|
Bud & Mike,
Thanks for the lead and suggestions. John |
| All times are GMT -7. The time now is 09:02 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: