|
Ford Windsor/Jerico spigot/pilot bearing?
My new SKF ballbearing pilot bearing, has been installed flush with the crankshaft, nice interference tap in fit with a socket, I could drive it in another maybe 1/4" or more until it comes up on a shoulder. My transmission spigot shaft has enough length, if I were to go that extra distance!
Does it matter, or maybe the bearing I have which is for the Jerico at 11mm wide and 15mm center hole, is quite a bit narrower than the original Ford item, and should go up hard to hold it on the end to truly make sure its square? |
| All times are GMT -7. The time now is 12:14 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: