Expansion Tank modification
Somewhere, I saw an article or post about cutting the brackets on an expansion tank and rebrazing to get the tank lower. Some questions:
1) Does anyone know the wherebouts of such an article? I've searched hi and lo and can't find anything 2) Info from ERA says the seam of the tank to the center of the top hole should be 4.10 Can anyone confirm this to be correct? I don't have my body yet and hate to solder up a tank to find out I have to do it all over. Thanks Paul |
Paul, that dimension will fit an ERA...the only way to know if it's right for your car is to see if it fits, as there's different strokes for different folks...
Dan |
All times are GMT -7. The time now is 04:16 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: