|
Upper Radiator Tube
I am looking for input or source for the upper tube for an FE setup - the 90degree tube that goes in the upper line.
My info says it is 1 3/4" dia. I was going to order a bend from Summit but then I saw a post, warning about electrolysis in the system. Summit has aluminized stl tubing and stainless tubing, in 90 bends. I can't find a source of prebent aluminum. Does anyone have any suggestions? Tried Finishline and CobraRestorers but neither of them had one listed ???? Paul |
Contact Burns Stainless in Southern California. They have mandral bends in Aluminum and Stainless. Good service. I have used them several times.
http://www.burnsstainless.com/Alumin...minumtube.html |
Paul, let us know what you find...
Dan |
| All times are GMT -7. The time now is 02:36 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: