|
Roush 427R and Quick Fuel QFT 750 jet sizes?
Hi!
Anyone around with a Roush 427R and a QFT 750? It would be helpful for me to know what Powervalve and jetsizes you are running. Will post mine today evening. (I know sealevel, temperature and humidity makes some differences but a reference would be great) Thanks a lot! Peter |
Primary main jet:72
Secondary jet: 84 Idle air Bleed: 73/73 Hi speed bleed: 35/35 Pri Nozzle: 31 Sec. Nozzle: 31 Needle and seat: 110 Power valve: 9.5 |
Quote:
9.5 seems high for a PV. I believe most come with a 6.5. I run a 2.5 in my EM and a 4.5 in my ERA. |
yeah i thought the same...for this type of cam i should run a 4.5 or 4 PV. At the carburator there was a 6.0 installed and it was very lean below 2000 rpm - so lots of stumble. I get an advice to go with the PV to 9.5 and it was a lot better.
But think the right way will be to go with a 4.5 PV and increase the primary main jets. Thats why i was asking for infos from other members with the same engine. Peter |
If you're getting a stumble, try increasing your squirters to 33 or 35 and see if this helps.
|
My old days self learned rule of thumb----------starting jet sizes for Holley carbs worked out to be in the region of jet number sorta matching carb CFM ratings----IE-your 750 cfm carb I would begin with around #75 jets in the primaries and more times than not---would start with a 4.5 power valve just to be able to work on the normal driving tune before then advancing into the hard acceleration and WOT stuff----------
|
Hi!
Thanks a lot for the advices. I will buy some PVīs and jets and will then test the emissions again. Hotfingers, with squirter you mean the Primary nozzle? Thanks a lot and greetings from Austria Peter |
| All times are GMT -7. The time now is 04:13 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: