|
removing gasket adhesive or caulking
1 Attachment(s)
i purchased a camper that i had to remove a lot of caulking on and repair, and on a whim decided to try a heat gun, removed the stuff like butter using a steel putty knife heated by the gun and heating the caulking as i went along.
on an oil pan, with the 'right stuff' gasket maker which is like rubber glue stuck all along the rails as i hadn't used a conventional gasket, i tried it again. works great, in about 5 minutes i had completely removed most of the material, then used a wire brush on a bench grinder to clean the rest, total time probably less than 15 minutes. |
don't blow yourself up......lol
|
lol, yeah i was careful with that, the oil never even smoked.
|
| All times are GMT -7. The time now is 08:12 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: