- -
Trigo/Jag
(
http://www.clubcobra.com/forums/tires-wheels/112770-trigo-jag.html)
| redmt |
10-01-2011 10:16 AM |
Trigo/Jag
I bought a used set of Trigo's and the front hub thickness or depth of the wheel is too thick for the Jag front hub. The rears seem to be OK,,,I think. The front jag hub is about 5/8-3/4" shorter from the end of threads to the disc brake hub than the rear so there are not enough threads to completely thread the knock off on. I looked on the Trigo web site and see there is only 1 wheel listed for the 6 pins. Is there a different , longer hub available for the Jag? I know something has to change, I'm just not sure if it's the wheel or the hub.
I did read all the thread on the Contemporary forum but didn't see any definitive answer.
John
|
| mickmate |
10-01-2011 12:40 PM |
John you need to machine the thread length of the knockoffs off the back of the front wheels and drill the pin holes deeper. Wheel offsets are given in the manual.
|
| redmt |
10-01-2011 12:50 PM |
Quote:
Originally Posted by mickmate
(Post 1154259)
John you need to machine the thread length of the knockoffs off the back of the front wheels and drill the pin holes deeper. Wheel offsets are given in the manual.
|
Yes, that's what I'm starting to figure out. The offset is about 3/4" off from what the book says. That would give me plenty threads for the knock offs. After looking at the Trigo web site and they only offer 1 offset, I sort of figured it out that I needed to have them machined down. Thanks for verifying the fix for me. I knew that I could count on one of the board wizards to chime in. Thanks again. |
| All times are GMT -7. The time now is 09:05 PM. |
|
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link:
