|
Toploader clearances
Rebuilding a top loader wide ratio/ smaller shafts
1) What are desired clearances between the 1/ 2 and 3 / 4 shift forks to synchro slider grooves. 2) What is acceptable runout of an output shaft?? Done Google and forum searches but no joy. Does any body has a list of clearances pertaining to toploaders?? Thanks |
You need to call David Key at David Key Toploaders. He knows everything.
|
Thanks Tim. It is the weekend and everybody is closed. I know the builders, Top loader Heaven, Liberty, Dan Williams, Davis Key. Just hoped some of the common clearances would be out there of the folks who have done their 4 speeds. The tranny shifted fine but when I took off the cover discovered the input bearing cage was toast. When I go into something I like to check everything and do it once. Sometimes cross checking info helps too. Some of the senior guys know this stuff off the top of their heads or have books and data. I am six hours ahead of East Coast and have to plan the times.
Thanks |
Go to Classictiger.com
Learjockey1 How you doing speedie?? Go to the forum above and they have a complete rebuild of the toploader trans with endplay and clearances for rebuilding a trans. If you want to blue print it, you are looking for tighter clearances. Be careful with the bearings. Over the last couple of years they have become crap. Green and Timpken are made in China. Look for old stock if possible. Rick L.,
|
Thanks Rick !!
I knew you had a good source. I saw the Tiger link when dong the searches but should have paid more attention. Again, Thanks |
| All times are GMT -7. The time now is 05:12 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: