- -
Flywheel Torque
(
http://www.clubcobra.com/forums/transmission-talk/113970-flywheel-torque.html)
| flipscobra |
01-13-2012 04:12 PM |
Flywheel Torque
Whats the Torque Specs for a aluminum flywheel to crank an a PP to Flywheel
|
| mreid |
01-13-2012 05:02 PM |
|
| blykins |
01-13-2012 05:17 PM |
Factory or ARP bolts?
|
| Rick Parker |
01-13-2012 09:14 PM |
The pressure plate bolts will accept less torque into the aluminum flywheel than into cast iron. Don't over do it. A tip: Tighten a little AT&T a time while alternating in a cris-cross pattern, this will prevent over loading the threads on any individual bolt.
|
| flipscobra |
01-14-2012 08:59 AM |
Fly Wheel
They r ARP
|
| All times are GMT -7. The time now is 06:03 PM. |
|
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link:
