|
Tremec question
Hey Everyone,
I'm trying to decide which tranny I want to use. I'll probably go with some type of Tremec. How do I know which model I need? What are the differences between them? Mike |
Mike, Go to this site http://www.tremectransmissions.com/E...oducts/TKO.asp
scroll down the page and you will see the 5 speed TKO trans. 4 & 6 speeds are also on the site. |
Engine? Rear end ratio? Wheel and tire size? Intended use?
The above are needed for an informed opinion on the transmission. DonC |
Thanks for the website, Al. It should help me get some answers.
And Don... it sounds like I'm going to have to get more specific with my set up. All I know is that I'm shooting for 400+ ft/lbs of torque. A lot of your other questions are still up in the air. Thanks for your input, guys. Mike |
Mike:
You might want to spend some time at - http://www.368s.com/tools_rpm.phtml - This is a gear ratio calculator that's easy to use, just plug in the numbers, and can give you an idea of speeds/rpm/gear for different combinations. DonC |
Hi Thorconstr,
I will pick up my t600 tremec next week. got my shifter from Southern this week, very nice. Thanks for your input on the subject recently. Maurice Lawrence Sacramento Ps, My Keith Craft Shelby will be here in a week to 10 days. Yowzer |
Mike:
Just as a for instance my setup is as follows: Tremec TKO 600 w/ 0.82 fifth 3.07 final drive ratio 11X17 Wheels w/315X35X17 tires Engine is a 428 opened up to 450 cu. in and putting out somewhere around 450 hp. I spend a long time with the gear calculators trying different combinations until I arrived at the above. The car is/was intended to be a street driver from the start Power wise, if I simply snap the throttle open in either 1st or 2nd it will break the rear wheels loose but it's a very tractable setup on the street as long as I don't get rambunctious. Highway cruise at 70 gives me about 2300 rpm and I hear more wind noise than exhaust. All of the components inter-relate with eachother in figuring out your final setup. Take some time and consider the final combination before you commit to it. Sometimes the morning after will bring some considerations into light that you hadn't considered the night before. DonC |
Hey Don...I never realized that there was so much involved in picking out a tranny. But I know I definitely want to get it right. My car won't even be delivered for 2 more weeks, so I still have some time to figure it all out. I'm sure I'll be back to this forum for more info. Thanks!
Mike |
| All times are GMT -7. The time now is 04:39 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: