Help Tilton Hydraulic Bearing Info

Scott S · #1 (**permalink**) 04-19-2006, 02:38 PM

Wayne,

What bore size of master cylinder did you use?

Scott S

cdnus · #2 (**permalink**) 04-20-2006, 06:05 PM

Thanks Wayne for the info.
Looks like I am going to have to drill my flywheel to acept the 10.5" clutch as the only patterns it has are for the long style clutches.
My other choice is to make a spacer for the transmision. Going to do some calculations tonight & make a decision. Need to get this done! The weathers great the roads are almost clear & my wild side is starting to itch. Almost time to make some noise.
Thanks again
Craig

Wayne Maybury · #3 (**permalink**) 04-21-2006, 07:05 AM

Craig

I am certainly no expert on flywheels and clutches but be very careful drilling a flywheel. If you are off by even a few thousands of an inch, you will almost certainly have a vibration. If you go this route make sure that it is done by someone that has lots of experience in this area. This is not an easy thing to do. You maybe better off to just buy a new flywheel, more dollars but less problems later on.

Good luck,
Wayne