|
Slave Cylinder Help Needed
I will be getting a Shelby kit Cobra with 351 SB and McLeod scattershield, flywheel, and 12" single disk cltuch. Also putting in a Tremec TKO 600 RR (.82).
I need a hydraulic clutch slave cylinder to go with my AFCO master cylinder. What brand of slave cylinder has proven to be a good quality piece - a part # would be helpful. Also what should I do about a mounting bracket for this slave cylinder? Does someone make a bracket that will bolt up directly or do I have to make my own? Scott |
Scott,
Call Mike Forte and ask him about slaves and brackets. I know he has a couple different kinds of set ups. Larry http://www.fortesparts.com/ |
Scott;
Try McLeod. They make both the slave and the bracket. Bill Stradtner |
| All times are GMT -7. The time now is 08:39 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: