Hi Richard
My name is Mick (mudbrick/AP build#32) on forum, would like to pick your brain on the engineering/rego process as hopefully I'm a couple of months away starting. Like you I have the car at Neil's (last 6mths) Pete doing wiring and across the road for paint. I'll assume that Troy Brodie was your engineer. I also understand that RMS are somewhat harder on process now(also rechecking) so things have changed.
Q: did you use u'car sys for emissions/noise then swap to live side pipes
Q: dash pad/visor padding changed a'f rego
Q: dust boots/seals on push rods/arms etc
Q: length of time from when testing done to RMS inspection to RMS issue of vin/rego paper work
Anything else would be appreciated, had hoped to get it on the road by e.o july but not hopeful
Thanks
Mick
email -
michaeljcowan@yahoo.com.au
