Conversation Between saltshaker and 1BIG67AC
Showing Visitor Messages 1 to 3 of 3
-
I’ll think about it. Right now my mind is on these exhaust. Trying to figure out why their not fitting correctly.
-
I think I have a set off my old A&C they would need new bushings etc. 1note about their suspension; you must make sure your wheelbase measured from center of front hub to center of rear hub is 90” otherwise if it is shorter the top of the pinion will hit the crossmember breaking the rear axle. I also have another 9” rear from my A&C with welded brackets to adjust the lower control arm brackets for more traction.
jon
-
I think I have a set off my old A&C they would need new bushings etc. 1note about their suspension; you must make sure your wheelbase measured from center of front hub to center of rear hub is 90” otherwise if it is shorter the top of the pinion will hit the crossmember breaking the rear axle. I also have another 9” rear from my A&C with welded brackets to adjust the lower control arm brackets for more traction.
jon