Conversation Between LMH and Robert Beede
Showing Visitor Messages 1 to 1 of 1
-
LMH: Greetings from a long-time AC COBRA owner, CSX 2073, since 1967! Dan Case knows me. I found an old thread on the forum where you were planning on machining your own wheel hubs. Your post suggested you had access to the British-Whitworth broaching tool to reproduce the correct spline configuration. I have one Steel adapter for the American Racing Torque Thrust style wheel which was made by someone using the wrong broach. It is VERY close to the correct form, and I was hoping to avoid the high cost of making this part from scratch. Do you think there’s a chance of re-broaching the existing splines using the proper British broach? I failed in my efforts to send you photos, but would gladly do so via Email if you thought you could help me. Thanks in advance for the courtesy of a reply! Best, Bob
