About Me
- About Daytona Dek
- City
- Northampton
- State
- UK
- Country
- United Kingdom
- Cobra Make, Engine
- Shell Valley Daytona, Ford 302
- Ride
- Shell Valley Daytona
- Engine type and displacement
- 302 Ford
- Tranny type
- Manual
Likes Given
42 Likes
-
Daytona Dek liked post by CSX2345 On thread : Cobra Daytona Coupe CSX2286Hello All, Here are a few images of CSX2286 at the Monterey Historic Reunion this past weekend. CheersLiked On: 08-19-2024, 04:14 AM
Posted On: 08-18-2024, 10:18 PMDaytona Dek liked post by patrickt On thread : Hot starting problem.Or... we could write down every possible repair we can think of on pieces of paper and then put them all in a hat. Every couple of days the OP pulls a piece of paper out of the hat and performs that...Liked On: 06-10-2024, 12:32 PM
Posted On: 06-09-2024, 10:23 AMDaytona Dek liked post by Tommy On thread : Hot starting problem.We're wandering into the percolation vs. evaporation vs. vapor lock conversation. The approach to each is different. As was noted in the earliest replies, diagnosis is the best first step.Liked On: 06-10-2024, 12:31 PM
Posted On: 06-09-2024, 09:45 AMDaytona Dek liked post by cycleguy55 On thread : Hot starting problem.A 'bypassing' fuel regulator has a return line that carries the fuel back to the tank that's not needed by the carburetor. That maintains a flow of cool fuel, whereas a 'blocking' type regulator...Liked On: 06-10-2024, 12:31 PM
Posted On: 06-09-2024, 03:35 PMDaytona Dek liked post by Tom Kirkham On thread : Hot starting problem.In addition to what others have recommended, look into a bypassing fuel pressure regulator. It works extremally in curing vapor lock.Liked On: 06-10-2024, 12:20 PM
Posted On: 06-08-2024, 03:19 PMLinks monetized by VigLinkDaytona Dek liked post by Bobcat On thread : Hot starting problem.Here are two other suggestions that would probably work well if it is heat soak . I run a wood insulator under the carb that is readily available from Summit in various thicknesses . Seems to work...Liked On: 06-10-2024, 12:19 PM
Posted On: 06-06-2024, 06:53 PMDaytona Dek liked post by Argess On thread : Hot starting problem.I had this problem and cured it with some silicone tubing over the fuel line as well as changing the line from copper to steel. Steel doesn't absorb heat like copper. Here's a "before" pic: ...Liked On: 06-10-2024, 12:16 PM
Posted On: 06-06-2024, 09:05 AMDaytona Dek liked post by mrmustang On thread : Hot starting problem.For all of my race cars, I prefer the Mr Gasket kit, part # 3710 , as it gives more options. You only need one heat shield, and two gaskets, and do not have to use the whole kit. Dozens upon...Liked On: 06-07-2024, 03:38 AM
Posted On: 06-05-2024, 02:55 PMDaytona Dek liked post by Gaz64 On thread : Hot starting problem.Open the throttle to about 1/3 initially. If it struggles to start, at least you haven't flooded it worse. While it is cranking, open the throttle wide. As soon as it fires, back off and control...Liked On: 06-07-2024, 03:38 AM
Posted On: 06-05-2024, 06:23 AMDaytona Dek liked post by Argess On thread : Sharing some funny Cobra memes…Actually, that was one of a few I did and made a video. Music "hey Little Cobra" and apparently was a copyright infringement and won't play in some countries. crlOxoAdWBILiked On: 04-27-2024, 03:06 AM
Posted On: 04-25-2024, 02:55 PMDaytona Dek liked post by Tommy On thread : Car show with ten CobrasI asked the show organizer to contact the Cobra owner about the paint. The reply was, "The color is a Orion paint starset red candy pearl."Liked On: 04-16-2024, 12:07 PM
Posted On: 04-15-2024, 09:41 AMDaytona Dek liked post by Tommy On thread : Car show with ten CobrasYesterday an annual curated car show was held for the third year in downtown Auburn, Alabama. They solicit participants for the no-cost event months in advance and select the eighty or so who get...Liked On: 04-14-2024, 01:04 PM
Posted On: 04-14-2024, 05:17 AMDaytona Dek liked post by Alfa02 On thread : The Best 8 and a half minutes in a Cobra.Jenson Button, has pretty quick hands too ;) It takes a F-1 world Champion to tame a Cobra :3DSMILE: Enjoy Gentlemen. https://www.youtube.com/watch?v=Drl175t-KEELiked On: 04-10-2024, 11:21 AM
Posted On: 04-10-2024, 06:18 AMDaytona Dek liked post by Ron61 On thread : New, New Chat Threadtesting the quote feature.Liked On: 12-20-2023, 12:49 PM
Posted On: 12-17-2023, 06:50 AMDaytona Dek liked post by twobjshelbys On thread : getting antifreeze stains off AluminumDenatured alcohol is my go to first solvent. It's much less harsh than petroleum solvents like paint thinner. It also (at least how I've used it) never affected color, so if you spill paint on...Liked On: 10-16-2023, 03:06 AM
Posted On: 10-14-2023, 04:17 PM
All times are GMT -7. The time now is 09:45 PM.





Likes Received