Club Cobra GasN Exhaust  

Go Back   Club Cobra > Members List
Reload this Page Davidless's Profile
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts


Davidless
CC Member

Last Activity: 09-16-2024 07:36 AM

About Me

  • About Davidless
    State
    Us
    Country
    Usa

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. Blas
    08-17-2023 10:46 AM - permalink
    Blas
    Oops…. Phone number is 847-420-7052
    Blas

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 09-16-2024 07:36 AM
  • Join Date: 07-05-2022

Likes Given

78 Likes
  1. Davidless
    Davidless liked post by eschaider On thread : Clutches, flywheels?
    What you end up using is, in large part, driven by your power level and driving style. This is a picture of the clutch I use; http://www.clubcobra.com/photopost/data/500/Pieces1.png...
    Liked On: 07-18-2023, 02:47 PM
    Posted On: 07-18-2023, 09:46 AM
  2. Davidless
    Davidless liked post by eschaider On thread : Remote Oil Line
    When we begin to look at the impact on performance that forged vs streamline elbows cost us on fluid system performance, it is equally impressive. The first pic I have posted below is the visual...
    Liked On: 07-15-2023, 08:11 PM
    Posted On: 07-14-2023, 10:59 PM
  3. Davidless
    Davidless liked post by Morris On thread : Remote Oil Line
    For every 90* degree fitting you add 10’ft of hose length....45* degree fittings add 5’ft of hose length.... Add the fittings up and go figure if you want to play “I know more then the pros”
    Liked On: 07-15-2023, 08:08 PM
    Posted On: 07-14-2023, 06:55 PM
  4. Davidless
    Davidless liked post by eschaider On thread : Remote Oil Line
    You are playing Russian Roulette with AN -10 fittings in the oil supply/delivery system. If you drive the car like a Sunday go-to-meeting car, it doesn't matter. If you drive it aggressively, even...
    Liked On: 07-14-2023, 01:07 PM
    Posted On: 07-14-2023, 08:29 AM
  5. Davidless
    Davidless liked post by Unique427 On thread : Remote Oil Line
    Canton's remote filter kit #22-829 at Summit Racing includes AN-10 braided lines. If it's just a remote with a short run AN-10 is sufficient. If you plan on plumbing in extras like an oil...
    Liked On: 07-14-2023, 01:07 PM
    Posted On: 07-14-2023, 05:02 AM
  6. Davidless
    Davidless liked post by bobcowan On thread : Remote Oil Line
    Canton and Earls recommends -10. Hamburger's recommends -12. I use -10 without any problems.
    Liked On: 07-13-2023, 09:07 PM
    Posted On: 07-13-2023, 08:06 PM
  7. Davidless
    Davidless liked post by Morris On thread : Remote Oil Line
    AN -12 only
    Liked On: 07-13-2023, 09:07 PM
    Posted On: 07-13-2023, 06:02 PM
  8. Davidless
    Davidless liked post by cycleguy55 On thread : Electric Fuel Pump
    I believe Carter pumps have often been recommended for those looking for quieter pumps.
    Liked On: 07-13-2023, 12:45 PM
    Posted On: 07-12-2023, 05:13 PM
  9. Davidless
    Davidless liked post by Grubby On thread : Electric Fuel Pump
    The Holley in tank pumps that mount similar to OE come in a wide range of volumes and pressures. They are very quiet. Holley 12-129 is a good for carbs/no return/600+ HP John
    Liked On: 07-13-2023, 12:45 PM
    Posted On: 07-12-2023, 02:35 PM
  10. Davidless
    Davidless liked post by KarlzEE Bebout On thread : Electric Fuel Pump
    Why do you want it to be quiet? The only time you'll hear it would be when you first turn on the key. Really doubt you'd hear it with the engine running.
    Liked On: 07-13-2023, 12:45 PM
    Posted On: 07-12-2023, 02:02 PM
  11. Davidless
    Davidless liked post by Campy On thread : electric fuel pump mounting
    Ditto on putting the pump on the outside and on the frame rail. I have a Holley Red pump. Works great, a tad on the noisy side, that's until the engine starts, of course!!! :3DSMILE: :3DSMILE: My...
    Liked On: 07-12-2023, 02:46 PM
    Posted On: 04-05-2002, 01:39 PM
  12. Davidless
    Davidless liked post by timsullivan On thread : Fuel system question?
    New Superformance rollers come from the factory with an inline fuel filter mounted at the rear axle area nearby the wiring loom for wiring in a electric fuel pump. Saying this, an electric fuel pump...
    Liked On: 06-26-2023, 02:23 PM
    Posted On: 08-05-2010, 10:11 PM
  13. Davidless
    Davidless liked post by Mark IV On thread : Oil cooler hookup
    Use the Quicktime. Steel construction and we have never had one that was out of spec for runout. The non-SFI unit is fine unless you are going racing and need the certification.
    Liked On: 06-15-2023, 10:47 AM
    Posted On: 06-15-2023, 04:38 AM
  14. Davidless
    Davidless liked post by eschaider On thread : RE: Bellhousing advice
    Unless you go the race-only route which has heartburn for a street-driven car the best choice and essentially the only game in town today is Quicktime. I believe they bought out Lakewood, and Holley...
    Liked On: 06-15-2023, 10:46 AM
    Posted On: 06-14-2023, 06:24 PM
  15. Davidless
    Davidless liked post by DanEC On thread : RE: Bellhousing advice
    QuickTime seem to have a good reputation for quality. I have one in my ERA and it centered nicely when I checked it with a dial indicator.
    Liked On: 06-15-2023, 10:45 AM
    Posted On: 06-14-2023, 05:41 PM
Page 5 of 6 1234 5 6

All times are GMT -7. The time now is 10:08 AM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink