About Me
- About jkg2101
- State
- NY
- Country
- usa
- Cobra Make, Engine
- Kirkham
- Engine type and displacement
- FE sideoiler
- Tranny type
- toploader
Likes Received
13 Likes
-
ERA 626 liked post by jkg2101 On thread : New FE build BBM block and headsFinal note for now: I am using a cam with a lot of lift, and a lot of duration. It really is incredible above 3000 rpm. If I could do it all over again, I would go with less duration. It's just a...Liked On: 08-04-2020, 01:12 PM
Posted On: 07-22-2017, 04:56 PMCobrafann liked post by jkg2101 On thread : Kirkham for saleFirst I must clarify that I have wanted this car for at least 25 years, and it took me a long time to get it. I wish I could keep it forever, but i am literally afraid to drive it on the track, and...Liked On: 06-22-2020, 10:37 PM
Posted On: 01-31-2020, 06:08 PM1985 CCX liked post by jkg2101 On thread : Suspension alignmenthere are some additional shots of front and rear suspension, for your viewing pleasure (as requested by a few interested folks)Liked On: 02-21-2020, 06:01 PM
Posted On: 02-26-2017, 04:34 PMLinks monetized by VigLinkSawdust liked post by jkg2101 On thread : Kirkham for saleFirst I must clarify that I have wanted this car for at least 25 years, and it took me a long time to get it. I wish I could keep it forever, but i am literally afraid to drive it on the track, and...Liked On: 02-01-2020, 07:16 AM
Posted On: 01-31-2020, 06:08 PMAlfa02 liked post by jkg2101 On thread : Kirkham for saleFirst I must clarify that I have wanted this car for at least 25 years, and it took me a long time to get it. I wish I could keep it forever, but i am literally afraid to drive it on the track, and...Liked On: 02-01-2020, 01:17 AM
Posted On: 01-31-2020, 06:08 PMt walgamuth liked post by jkg2101 On thread : Kirkham for saleUnfortunately, i am putting my Kirkham 427 up for sale. I have wanted this car for a lifetime, and I have had the pleasure of owning for a short while now. But financial and physical concerns make...Liked On: 12-29-2019, 06:12 AM
Posted On: 12-25-2019, 03:09 PMMorris liked post by jkg2101 On thread : WTB enclosed trailer lightweighthi - i am looking to buy an enclosed trailer - must be lightweight since I will be using regular SUV to tow. Montrose and Trailex both make very light but expensive trailers (2000lbs) like this. ...Liked On: 01-18-2019, 06:38 PM
Posted On: 01-18-2019, 05:03 AMsteve meltzer liked post by jkg2101 On thread : Replacing the rear main seal on side oilerI replaced the rear main seal with engine in car. The cross member is a pain to work around but it can be done. Hardest part was getting the main cap off. I can give you my tricks tomorrow if...Liked On: 06-05-2018, 03:06 PM
Posted On: 06-04-2018, 08:07 PM1985 CCX liked post by jkg2101 On thread : Suspension alignmentNow to the front suspension – Front tire camber is really easy to set on a Kirkham. The lower control arm has these neat adjustments at the attachment to the frame. The rod ends can be pulled...Liked On: 02-15-2017, 04:28 PM
Posted On: 02-15-2017, 04:20 PM1985 CCX liked post by jkg2101 On thread : Suspension alignmentNow that I am happy with camber, I double check the toe in with the fastrax. Strap the fastrax to the rear tire with a bungee cord, and use the legs to measure with a tape measure to the front and...Liked On: 02-15-2017, 04:28 PM
Posted On: 02-15-2017, 04:18 PM1985 CCX liked post by jkg2101 On thread : Suspension alignmentNext I set the rear camber. On the Kirkham, this is easy. First measure with fastrax. I was positive 1 degree. At the rear suspension, when the car was delivered, the only loose rear suspension...Liked On: 02-15-2017, 04:28 PM
Posted On: 02-15-2017, 04:17 PM1985 CCX liked post by jkg2101 On thread : Suspension alignmentFirst I set ride height on the front and rear. Just under 6” at the rear, and 5” at the front. Others may want theirs lower. This is easily done by adjusting the Penske coilover shocks. Of note,...Liked On: 02-15-2017, 04:28 PM
Posted On: 02-15-2017, 04:14 PMmoore_rb liked post by jkg2101 On thread : What's the appeal of an aluminum engine block?In response to the original question on this thread, I am currently building my kirkham (finally received it!). I purchased an assembled 'short block' from Blair Patrick (who I might add is very...Liked On: 11-23-2016, 08:48 AM
Posted On: 11-22-2016, 04:40 PM
All times are GMT -7. The time now is 10:20 AM.






Likes Received