Club Cobra Keith Craft Motorsports  

Go Back   Club Cobra > Search Forums
Reload this Page Search Results
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts

MMG Superformance
Nevada Classics
Keith Craft Racing
Main Menu
Portal
Forums

Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
MMG Superformance
Advertise at CC
Banner Ad Rates
MMG Superformance
Keith Craft Racing
February 2026
S M T W T F S
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
Page 1 of 4 1 234
Showing results 1 to 25 of 79
Search took 0.04 seconds. Search: Posts Made By: PHMCobra
Forum: ALL COBRA TALK 09-24-2020, 11:14 AM
Replies: 5
Views: 41
Posted By PHMCobra
My Backdraft Cobra with Roush 427R and Tremec...

My Backdraft Cobra with Roush 427R and Tremec 6-speed tranny has been serviced by Venom Classics in Mesa, AZ. Terry Hinton and wife, Mary Hinton, run a first class, full service operation...
Forum: Arizona Cobra's 08-21-2020, 01:58 PM
Replies: 8
Views: 50
Posted By PHMCobra
JRJBDR, I posted my experience in registering...

JRJBDR,
I posted my experience in registering my BDR a few years back. As following:

I recently purchased a new Backdraft Cobra out-of-state. Getting Title and Registration with Historic Plates...
Forum: Arizona Cobra's 04-24-2020, 09:15 AM
Replies: 11
Views: 43
Posted By PHMCobra
Welcome to the world of the Cobra. Sounds like...

Welcome to the world of the Cobra. Sounds like you have a major project ahead. I have a beauty queen Backdraft Cobra that is 5 years old with 2200 miles on it. It is truly like new and mostly gets...
Forum: Transmission Talk 05-17-2019, 12:35 PM
Replies: 17
Views: 1,034
Posted By PHMCobra
I have a T56, 6-speed manual tranny in my...

I have a T56, 6-speed manual tranny in my Backdraft Cobra transferring 551 HP to my rear wheels. Shifting in all gears is so smooth. Great tranny--might weigh a bit more than the 5-speed trannies,...
Forum: Arizona Cobra's 03-22-2019, 04:51 PM
Replies: 5
Views: 730
Posted By PHMCobra
I am the original owner Backdraft #1360, Sterling...

I am the original owner Backdraft #1360, Sterling Grey with Silver stripes and black interior and most all of the Backdraft options sold as new. The car has a Roush 427R engine (551 HP, 528 Ft-Lbs...
Forum: BackDraft Racing --- 11-23-2018, 04:33 PM
Replies: 8
Views: 907
Posted By PHMCobra
Similar problem with starting my Cobra (BDR 1360,...

Similar problem with starting my Cobra (BDR 1360, Roush 427, 550 HP with Holley Carb). The Cobra ran fine for 700+/- miles and then was hard to start. One morning, the car did not start immediately....
Forum: Arizona Cobra's 09-05-2018, 06:24 PM
Replies: 5
Views: 477
Posted By PHMCobra
SkipB, Hey, I am interested and will plan on...

SkipB,

Hey, I am interested and will plan on attending the Islands Car Show this year. I'll review the flier and fill out the entry form. Phil
Forum: BackDraft Racing --- 09-02-2018, 03:59 PM
Replies: 9
Views: 664
Posted By PHMCobra
I have BDR #1360 with a Rouse 427R (550 HP) with...

I have BDR #1360 with a Rouse 427R (550 HP) with similar flange connections as you have. After reading your Post, I inspected my flange connections and discovered that one bolt on the passenger side...
Forum: ALL COBRA TALK 07-29-2018, 09:30 AM
Replies: 2
Views: 307
Posted By PHMCobra
I had the same problem identifying my particular...

I had the same problem identifying my particular Tremec tranny in my Backdraft. I contacted Darin Stocker, Customer Service Rep at Tremec (darin.stocker@tremec.com) and he told me the metal tag...
Forum: BackDraft Racing --- 07-03-2018, 08:40 AM
Replies: 23
Views: 2,613
Posted By PHMCobra
First-time riders should wear a diaper. Too many...

First-time riders should wear a diaper. Too many first-time riders have soiled undies!
Forum: Arizona Cobra's 07-03-2018, 08:35 AM
Replies: 1
Views: 273
Posted By PHMCobra
For minor work, I have used Sundevil Auto Service...

For minor work, I have used Sundevil Auto Service located near Riggs and Dobson (Dave is the manager--a knowledgeable guy). Probably OK for the work you want performed. For larger project work, I...
Forum: Superformance 07-02-2018, 09:12 AM
Replies: 15
Views: 772
Posted By PHMCobra
Does the SPF Turn Signal Adjustment procedure...

Does the SPF Turn Signal Adjustment procedure listed above by Mark IV work for late model Backdraft Cobras?
Forum: BackDraft Racing --- 06-01-2018, 01:51 PM
Replies: 7
Views: 1,000
Posted By PHMCobra
The VIN # on the plate located on the upper...

The VIN # on the plate located on the upper firewall on the driver's side is the same VIN # stamped in the cross frame that has the radiator reservoir attached (at least on my Backdraft R3 Cobra). My...
Forum: BackDraft Racing --- 05-29-2018, 03:58 PM
Replies: 23
Views: 3,340
Posted By PHMCobra
I purchased a prop rod assembly directly from...

I purchased a prop rod assembly directly from Backdraft in Florida years ago for my Backdraft #101. The prop rod installed easily and the mount on the hood was easy to install. Worked well for me....
Forum: BackDraft Racing --- 04-24-2018, 02:48 PM
Replies: 10
Views: 743
Posted By PHMCobra
Ace Hardware. I took one of my hood screws to Ace...

Ace Hardware. I took one of my hood screws to Ace and they had the screws and nuts. Ace has a super good inventory of hard to find screws, nuts and associated hardware. Give them a try.
Forum: ALL COBRA TALK 04-12-2018, 05:38 PM
Replies: 314
Views: 15,520
Posted By PHMCobra
I have owned two Backdraft Cobras both with more...

I have owned two Backdraft Cobras both with more the 500 HP powering the vehicle as delivered from the factory. I have experienced windshield problems until I replaced the glass with Lexon MR10. I...
Forum: BackDraft Racing --- 04-07-2018, 06:08 PM
Replies: 6
Views: 626
Posted By PHMCobra
I purchased my BDR (#1360) and the car was...

I purchased my BDR (#1360) and the car was delivered without any black gaskets between the turn signal/brake light or any other turn signal in the front of the car. I do not understand why Backdraft...
Forum: Transmission Talk 03-29-2018, 08:04 PM
Replies: 8
Views: 800
Posted By PHMCobra
Missed and important word in my last Post. I HAVE...

Missed and important word in my last Post. I HAVE HAD NO PROBLEMS SINCE CLEANING THE TRANNY WIRE TO THE SPEEDO WIRE. Good luck in your fix!
Forum: Transmission Talk 03-29-2018, 07:57 PM
Replies: 8
Views: 800
Posted By PHMCobra
Similar problem with my Backdradft Cobra...

Similar problem with my Backdradft Cobra (1360)--shortly after I purchased the car. The speedometer would jump erratically at times just as you have described. I cleaned the electric coupling from...
Forum: Australian Cobra Club 03-24-2018, 06:16 PM
Replies: 40
Views: 3,485
Posted By PHMCobra
My Backdraft Cobra has a Roush 427R engine (550...

My Backdraft Cobra has a Roush 427R engine (550 HP, 528 FT.LBs.) and power is transferred through a Tremec T-56 Magnum 6-speed manual Transmission (Model TUET11010). The drive shaft is connected to a...
Forum: BackDraft Racing --- 03-15-2018, 01:10 PM
Replies: 6
Views: 1,560
Posted By PHMCobra
I have owned two Backdraft Cobras. My first Cobra...

I have owned two Backdraft Cobras. My first Cobra was an early Cobra model (#101). I currently own Backdraft #1360. My first backdraft was purchased used and although the mileage was low, the car had...
Forum: BackDraft Racing --- 03-15-2018, 11:24 AM
Replies: 13
Views: 943
Posted By PHMCobra
Congrats. You now own a beautiful Backdraft...

Congrats. You now own a beautiful Backdraft Cobra. I twin sister to mine--same color combination, same wheels and same great drive. I wish you the same fun and enjoyment in your new Cobra as I have...
Forum: ERA---Speak with Bob Putnam 03-08-2018, 07:59 AM
Replies: 13
Views: 1,194
Posted By PHMCobra
I had slip-on sidepipes on my early Backdraft...

I had slip-on sidepipes on my early Backdraft build that also proved difficult to remove. I attached one end of hand-crank come-alongs to the sidepipe near the 90-degree bend and the other end to a...
Forum: BackDraft Racing --- 03-04-2018, 02:51 PM
Replies: 27
Views: 2,520
Posted By PHMCobra
Chris, pleased to hear you purchased a like-new...

Chris, pleased to hear you purchased a like-new Backdraft Cobra. And your purchase was from VMS, much closer to home. Enjoy your Cobra as I do mine. Phil
Forum: ALL COBRA TALK 02-12-2018, 05:06 PM
Replies: 21
Views: 1,658
Posted By PHMCobra
I garage my car 100% when not on the road. If...

I garage my car 100% when not on the road. If garaged for more than a few days, I cover the car with BUDGE #2 grey cover. Works great and certainly affordable.
Showing results 1 to 25 of 79
Page 1 of 4 1 234

 

All times are GMT -7. The time now is 10:41 AM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink