Club Cobra Gas - N Exhaust  

Go Back   Club Cobra > Search Forums
Reload this Page Search Results
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts

MMG Superformance
Nevada Classics
Main Menu
Portal
Forums

Module Jump:
Nevada Classics
Nevada Classics
Keith Craft Racing
Advertise at CC
Banner Ad Rates
Keith Craft Racing
Keith Craft Racing
Keith Craft Racing
Keith Craft Racing
May 2026
S M T W T F S
          1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31            
Page 1 of 4 1 234
Showing results 1 to 25 of 100
Search took 0.03 seconds. Search: Posts Made By: kmarccoco
Forum: ERA---Speak with Bob Putnam 05-23-2009, 12:09 AM
Replies: 8
Views: 878
Posted By kmarccoco
Awesome!!! Thanks for the help!!

Awesome!!! Thanks for the help!!
Forum: ERA---Speak with Bob Putnam 05-22-2009, 04:13 PM
Replies: 8
Views: 878
Posted By kmarccoco
Thanks guys. The diagram is a little confusing to...

Thanks guys. The diagram is a little confusing to me. mabey I have to look under car to make sence of it. Im cutting wires only to the outter terminal, removing it, installing the new one, removing...
Forum: ERA---Speak with Bob Putnam 05-22-2009, 12:29 PM
Replies: 8
Views: 878
Posted By kmarccoco
Brake sending unit

Hi there, I remember you told me about the replacement ford part number for the brake sending unit . can you remind me again. My brake lights are not working. Thank you Sir..
Forum: Bay Area Cobra Club 06-10-2007, 01:11 PM
Replies: 42
Views: 4,782
Posted By kmarccoco
Very nice guy. there are pics of his shop in my...

Very nice guy. there are pics of his shop in my photos..
Forum: Shop Talk 06-10-2007, 01:08 PM
Replies: 9
Views: 1,053
Posted By kmarccoco
jb weld worked on mine

jb weld worked on mine
Forum: ALL COBRA TALK 06-08-2007, 04:38 AM
Replies: 0
Views: 529
Posted By kmarccoco
El Sobrante cobra sighting

yesterday i saw a sliver cobra on Apian way In El Sobrante.....:D

anyone wana claim respoonsibility????:)
Forum: ERA---Speak with Bob Putnam 04-08-2007, 10:46 PM
Replies: 2
Views: 640
Posted By kmarccoco
Bob, ill check the under dash harness. it did...

Bob, ill check the under dash harness. it did warm up, because as the problem was occuring while driving, i felt the harness near my left leg and it was warm, but not super hot. another wierd thing,...
Forum: ERA---Speak with Bob Putnam 04-07-2007, 09:18 PM
Replies: 2
Views: 640
Posted By kmarccoco
rear wireing harness failure

hi Bob. well tonight my rear drivers side tail lamp wireing harness melted pretty bad. i assume this happened from a short? all other wire components(front headlights and rear passenger side wires)...
Forum: NW Cobra Club 01-23-2007, 03:05 AM
Replies: 42
Views: 3,519
Posted By kmarccoco
what about the von dutch bus! they say it...

what about the von dutch bus! they say it undersold.
Forum: Shop Talk 12-04-2006, 06:03 PM
Replies: 23
Views: 2,268
Posted By kmarccoco
so then what is the best/safest oil temp? mine...

so then what is the best/safest oil temp? mine runs about 150-180 cool weather(but usually falls back to 150-160 quickly), and in hot weather 170-190. what temp is best for engines?
Forum: ERA---Speak with Bob Putnam 11-28-2006, 05:39 PM
Replies: 26
Views: 4,477
Posted By kmarccoco
vintage plates

hi gilby. the rosevlle flea market has a vendor there that sells old plates, he even has old month and year tags left over from real dmv stock. i have a vintage copy plate on mine that i bought off...
Forum: Shelby American, Inc. 11-07-2006, 05:51 PM
Replies: 232
Views: 28,820
Posted By kmarccoco
tognattis was out of the 180's so for now i got a...

tognattis was out of the 180's so for now i got a 160 to see if there is a difference.. pretty noticible diff.. ill try a 180 when they get one. 180 even in the summer?
Forum: Shelby American, Inc. 11-06-2006, 09:31 PM
Replies: 232
Views: 28,820
Posted By kmarccoco
really good. i just put a dang 160 thermostat in...

really good. i just put a dang 160 thermostat in car and runs better than without one. i was using the dove water tank that had the adjustable flow valve. was not working too well. better now with...
Forum: Shelby American, Inc. 11-05-2006, 10:04 PM
Replies: 232
Views: 28,820
Posted By kmarccoco
jdog, did you get any zaino yet???

jdog, did you get any zaino yet???
Forum: FE TALK 10-29-2006, 11:10 PM
Replies: 12
Views: 907
Posted By kmarccoco
michael, i rounded the passenger side off. they...

michael, i rounded the passenger side off. they were all within 1/2 to 1psi from 180. same with drivers side.

ok, well i feel better. thanks. i thought they should all be the same or close to the...
Forum: FE TALK 10-29-2006, 06:37 PM
Replies: 12
Views: 907
Posted By kmarccoco
thanks again guys. i used a actron compression...

thanks again guys. i used a actron compression gauge from sears....:>
Forum: FE TALK 10-29-2006, 11:08 AM
Replies: 12
Views: 907
Posted By kmarccoco
the carb was wide open.... are these readings...

the carb was wide open.... are these readings lower than should be? what should they be at? will this cause it to idle rough? or effect the performance?
Forum: FE TALK 10-28-2006, 07:10 PM
Replies: 12
Views: 907
Posted By kmarccoco
no smoke from exhaust that i can detect. it does...

no smoke from exhaust that i can detect. it does smoke out of the valve cover breathers though. no water consumption either. it didnt even smoke after i started it after leak testing number 5...
Forum: FE TALK 10-28-2006, 05:39 PM
Replies: 12
Views: 907
Posted By kmarccoco
strange compression readings

my new 428(2k miles) has been idleing a bit strange for a while now.

i conducted a compression check and here are the readings.

cylinders 1-4 180psi

cylinders

5) 165 dry ...
Forum: Shop Talk 10-21-2006, 03:24 PM
Replies: 5
Views: 676
Posted By kmarccoco
i jetted down to 80 squared. i t was 86 out of...

i jetted down to 80 squared. i t was 86 out of the box. i do not see a pcv vent at the bottom.

somthing a little different from my demon, is that the verticle transfer slot in the venturi of the...
Forum: Shop Talk 10-21-2006, 12:58 PM
Replies: 5
Views: 676
Posted By kmarccoco
smoke valvecover question

i swithced to a holley hp 830, and got away from my demon race. it seems to run alot better. the holley does not have a pcv valve vaccume hook up in the rear like the demon.

i now have noticed...
Forum: Shop Talk 09-29-2006, 12:11 PM
Replies: 33
Views: 2,839
Posted By kmarccoco
[QUOTE=Jac Mac]: Write your firing order...

[QUOTE=Jac Mac]:

Write your firing order down like this;( Lucky FE's all have same firing order):)

1 5 4 2
6 3 7 8

Now when the valves on #6 cyl are 'rocking' (...
Forum: Shop Talk 09-28-2006, 11:08 PM
Replies: 33
Views: 2,839
Posted By kmarccoco
thanks ya'all.. i will search for a few posts on...

thanks ya'all.. i will search for a few posts on the subject and give it a shot....
Forum: Shop Talk 09-28-2006, 10:24 PM
Replies: 33
Views: 2,839
Posted By kmarccoco
hahahah, how do you know?

hahahah, how do you know?
Forum: Shop Talk 09-28-2006, 10:00 PM
Replies: 33
Views: 2,839
Posted By kmarccoco
just asking because it seems fairly easy, and i...

just asking because it seems fairly easy, and i should learn to do it myself...
Showing results 1 to 25 of 100
Page 1 of 4 1 234

 

All times are GMT -7. The time now is 09:45 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink