Club Cobra Keith Craft Motorsports  

Go Back   Club Cobra > Search Forums
Reload this Page Search Results
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts

MMG Superformance
Nevada Classics
MMG Superformance
Main Menu
Portal
Forums

Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
Advertise at CC
Banner Ad Rates
MMG Superformance
MMG Superformance
November 2025
S M T W T F S
            1
2 3 4 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30            
Page 1 of 4 1 234
Showing results 1 to 25 of 100
Search took 0.08 seconds. Search: Posts Made By: JAM1775
Forum: ALL COBRA TALK 01-04-2012, 03:53 PM
Replies: 16
Views: 2,077
Posted By JAM1775
TKO 600 will give you a long first gear without...

TKO 600 will give you a long first gear without the higher revs. With 331's you could make 45-50mph easily in 1st without screaming revs. Perfect for your BB.
I also think the best OD for your...
Forum: ALL COBRA TALK 10-03-2011, 08:15 AM
Replies: 26
Views: 4,508
Posted By JAM1775
Sorry Bud....I was just offering to help if guys...

Sorry Bud....I was just offering to help if guys were considering something.... but had no idea what it would conceptually look like or how it would perform.
Forum: ALL COBRA TALK 10-01-2011, 06:53 AM
Replies: 26
Views: 4,508
Posted By JAM1775
Jason...where would the air intake /air cleaner...

Jason...where would the air intake /air cleaner be on that set up...behind the drivers side pump ?
Forum: ALL COBRA TALK 09-30-2011, 06:38 AM
Replies: 26
Views: 4,508
Posted By JAM1775
I have the Paxton Novi1200 on my SPF 392 stroker....

I have the Paxton Novi1200 on my SPF 392 stroker. I bought the car from a friend of mine a few months ago. The Paxton has been on the car for at least 5-6 years. He caught a deal on a polished...
Forum: Shop Talk 09-29-2011, 06:47 AM
Replies: 5
Views: 1,394
Posted By JAM1775
Thanks guys. I will do a closer inspection,...

Thanks guys. I will do a closer inspection, rotate the boot and if it's not split up top I will wrap a tie around it. !
I am new to SPF ownership bought this used from a buddy . What puzzles me...
Forum: Shop Talk 09-28-2011, 03:55 PM
Replies: 5
Views: 1,394
Posted By JAM1775
SPF Half Shaft CV Boot ?

I was under my car today visually inspecting and found GOBS of thick bearing grease all around the RR Suspension from the shock towers to the LCA's.
I am assuming the half shaft CV Boot is splt...
Forum: Transmission Talk 09-23-2011, 03:51 PM
Replies: 8
Views: 1,628
Posted By JAM1775
Okay guys I have the slave cylinder. I have not...

Okay guys I have the slave cylinder. I have not yet installed it but it's a dead match. NAPA Part # 73470
Thanks for all your help !
Jam
Forum: Transmission Talk 09-22-2011, 09:04 AM
Replies: 8
Views: 1,628
Posted By JAM1775
Ok thanks....gotta get under my car.

Ok thanks....gotta get under my car.
Forum: Transmission Talk 09-22-2011, 08:39 AM
Replies: 8
Views: 1,628
Posted By JAM1775
I looked up that Autozone part which shows Part #...

I looked up that Autozone part which shows Part # 11206'
I just sent STL MARK a PM to verify .

Thanks !
jam
Forum: Transmission Talk 09-22-2011, 07:24 AM
Replies: 34
Views: 8,519
Posted By JAM1775
The Tremec 600 with a 2.87 first gear + OD would...

The Tremec 600 with a 2.87 first gear + OD would be a nice package and comes with the Hurst short throw shifter. I love that set up for my car. Of course, it's a bit notchier than your T5Z. Not...
Forum: Transmission Talk 09-22-2011, 06:47 AM
Replies: 8
Views: 1,628
Posted By JAM1775
SPF Slave Cylinder Part #

Can anyone please tell me the part # of our SPF slave cylinder from Mike Forte's ?
Or...NAPA ( right near me)
Or...Summit Racing ?

Thanks !
jam
Forum: Transmission Talk 09-09-2011, 05:45 PM
Replies: 17
Views: 1,690
Posted By JAM1775
Hah ! Hey John Hall....I have the Wallace link...

Hah ! Hey John Hall....I have the Wallace link in my favorites and have refeered to it many times especially last year when I bought my GT500 ! Thanks Bud !

Thanks boys for all your help. As...
Forum: Transmission Talk 09-09-2011, 09:09 AM
Replies: 17
Views: 1,690
Posted By JAM1775
Thanks Jim.....I agree on the gearing especially...

Thanks Jim.....I agree on the gearing especially since I have the steeper 3.73's.
I will match up the slave this morning.
Forum: Transmission Talk 09-09-2011, 08:55 AM
Replies: 17
Views: 1,690
Posted By JAM1775
Don..... I just took out a calculator .... ...

Don.....
I just took out a calculator ....
Are my numbers messed up ?

I had 327's in the car with the Tremec 500 .68 OD Using a calcualtor just to compare ratios: 3.27 x .68 = 2.223

Now I...
Forum: Transmission Talk 09-09-2011, 06:10 AM
Replies: 17
Views: 1,690
Posted By JAM1775
Yikes....I have a .068 OD in my Tremec and it...

Yikes....I have a .068 OD in my Tremec and it feels fine at 60-65mph...the difference to .064 is something to consider !
Went on Summit last night but I think I need to get under the car again to...
Forum: Transmission Talk 09-08-2011, 08:00 PM
Replies: 17
Views: 1,690
Posted By JAM1775
Thanks again guys.....I am thinking of the .064...

Thanks again guys.....I am thinking of the .064 OD tranny...the motor has good low end torque. I also have a napa about a mile from my house !
Forum: Transmission Talk 09-08-2011, 09:12 AM
Replies: 17
Views: 1,690
Posted By JAM1775
Thanks guys....I will go from inside and just...

Thanks guys....I will go from inside and just swap the tranny for the 600....DONE !

I also just noticed the slave cylinder had a bit of leakage as I removed the boot seal. Plus it only pushes...
Forum: Transmission Talk 09-08-2011, 05:50 AM
Replies: 17
Views: 1,690
Posted By JAM1775
SPF Trans/Clutch Swap

I just purchased a Superformance.

Can the transmission be moved back allowing enough clearance to remove the McCleod shield and replace the clutch and instal an AL flywheel ??

This is an...
Forum: ALL COBRA TALK 09-10-2009, 06:37 AM
Replies: 6
Views: 926
Posted By JAM1775
Not to worry Bud. One might think that way. But...

Not to worry Bud. One might think that way. But there is nothing wrong with nitrous on a Cobra. It's just another power adder. . The movie was ...well...just a movie. Nitrous has been used under...
Forum: ALL COBRA TALK 09-08-2009, 06:42 AM
Replies: 6
Views: 926
Posted By JAM1775
Perfect kit is the Edelbrock 70001 carb plate...

Perfect kit is the Edelbrock 70001 carb plate system. It comes with 50/75/100HP jetting and the solenoids can support additional jetting at 125HP if you felt that was needed. The 50HP setting gets...
Forum: ALL COBRA TALK 04-13-2009, 07:35 PM
Replies: 46
Views: 6,466
Posted By JAM1775
Pman...you can bump up your power pretty good...

Pman...you can bump up your power pretty good with heads and a bit more squeeze. here are some of my 351W combos the past ten years.
Here's a dyno sheet with my 351W comparing both a Stealth and...
Forum: ALL COBRA TALK 04-11-2009, 01:53 PM
Replies: 135
Views: 15,774
Posted By JAM1775
patrickt....I did not see any reference to "FFR...

patrickt....I did not see any reference to "FFR guys" in the statement by vettestr. Rather than turn jackmi's thread in the wrong direction .....

I'd like to agree with each of Bill's comments as...
Forum: ALL COBRA TALK 03-16-2009, 07:47 AM
Replies: 23
Views: 2,360
Posted By JAM1775
2270 with 351W live axle, Tremec , half tank of...

2270 with 351W live axle, Tremec , half tank of fuel.
Forum: ALL COBRA TALK 03-04-2009, 03:25 PM
Replies: 56
Views: 8,468
Posted By JAM1775
AL Flywheel = great investment. Disadvantage...

AL Flywheel = great investment.
Disadvantage ....slightly more drag on the decel vs steel FW

Advantages
Decreases centrifigul weight on the motor & makes car feel lighter to motor
Decreases the...
Forum: Long Island Cobras 02-22-2009, 05:42 PM
Replies: 13
Views: 1,543
Posted By JAM1775
YUP !! I bundled up and went out yesterday for...

YUP !! I bundled up and went out yesterday for about 45 minutes.
My only regret was the ear warmers muffled the sound of the pipes !
Oh...the fingers were starting to go numb too. :D ...
Showing results 1 to 25 of 100
Page 1 of 4 1 234

 

All times are GMT -7. The time now is 08:06 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink