Club Cobra GasN Exhaust  

Go Back   Club Cobra > Search Forums
Reload this Page Search Results
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts

Nevada Classics
MMG Superformance
Main Menu
Portal
Forums

Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
Advertise at CC
Banner Ad Rates
MMG Superformance
Keith Craft Racing
MMG Superformance
MMG Superformance
April 2026
S M T W T F S
      1 2 3 4
5 6 7 8 9 10 11
12 13 14 15 16 17 18
19 20 21 22 23 24 25
26 27 28 29 30    
Showing results 1 to 10 of 10
Search took 0.02 seconds. Search: Posts Made By: loudpedal
Forum: All Racing Talk 07-06-2006, 08:39 AM
Replies: 22
Views: 6,888
Posted By loudpedal
Lightbulb locating a live axle.

C.H.

If I read right you have a 4 link locating a live axle. You don't mention the TYPE of 4 link you have...I can only assume that as you now have no locating devise (Watts, Panhard, ladder etc)...
Forum: Parts For Sale 07-03-2006, 10:03 AM
Replies: 0
Views: 522
Posted By loudpedal
Thumbs up Genuine Superformance factory shirts FS (3 oldies)

Way back in the last century when I was doing development work for Superformance cars..about '92-93.....we had some shirts made up for introduction shows/events.

Cleaning out the closet I found...
Forum: Consumer Watch 10-10-2001, 11:49 AM
Replies: 7
Views: 2,335
Posted By loudpedal
full bladdrs....gotta go!!!

The interior foam should be replaced every few years.

20 years on the same bladder is a lot! Usually 10-12 years is about it.

Either Fuel Safe or ATL have FIA FT3/5 approved bladder and can...
Forum: Shop Talk 10-10-2001, 11:39 AM
Replies: 7
Views: 1,374
Posted By loudpedal
cutting back the side electrode

is an old lawnmower trick.

It helps the motor run cleaner at lower rpm with a fat fuel mixture....(with mechanical injection for example).

The suffix J Champions were in fact pre cut back and...
Forum: Shop Talk 10-10-2001, 11:16 AM
Replies: 8
Views: 1,486
Posted By loudpedal
an answer for you....

Best deals on lots of acessories....

kalecoauto.com
Forum: FE TALK 10-10-2001, 10:54 AM
Replies: 1
Views: 1,137
Posted By loudpedal
pan...(orama)

Bet its a chrome offshore piece.

As long as it clears the crank throws, rod nuts and other engine internals it will work. You will have to check clearances carefully...these pans are good for a...
Forum: FE TALK 10-10-2001, 10:18 AM
Replies: 16
Views: 2,336
Posted By loudpedal
correct placement of pitot tube for oil temp

Make sure you have the sender for the oil temp gage placed correctly......

The tube on the sender should go all the way thru the adapter it is screwed into at least 1" to be well into the oil....
Forum: Shop Talk 10-09-2001, 04:11 PM
Replies: 6
Views: 1,015
Posted By loudpedal
Try this

flat floor and a helper.

car in second gear...push in clutch...roll car forward...slowly let out clutch pedal to find engagement positon. Note this position relative to pedal travel. Now do the...
Forum: All Racing Talk 10-09-2001, 03:57 PM
Replies: 4
Irs
Views: 968
Posted By loudpedal
IRS....owe any money???

In a road car you wont notice much of an improvement in handling ....assuming both the IRS and live axle are both set up correctly.

The IRS advantage shows up in less unsprung weight, and in the...
Forum: FE TALK 10-09-2001, 03:48 PM
Replies: 10
Views: 1,760
Posted By loudpedal
Smile an idea on dists for Fe's

Get a decent stock FE dist core.....one with good bushings and a good iron(if thats what ur using) gear.

Then get any pre 90 (thick film) and/ back to '74 any V8 dist with the magnetic trigger....
Showing results 1 to 10 of 10

 

All times are GMT -7. The time now is 11:41 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink