Club Cobra Keith Craft Motorsports  

Go Back   Club Cobra > Search Forums
Reload this Page Search Results
Portal Register FAQ Community For Sale Gallery Calendar Today's Posts

MMG Superformance
Nevada Classics
Main Menu
Portal
Forums

Module Jump:
Nevada Classics
Nevada Classics
Advertise at CC
Banner Ad Rates
Keith Craft Racing
MMG Superformance
Keith Craft Racing
Keith Craft Racing
November 2025
S M T W T F S
            1
2 3 4 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30            
Page 1 of 3 1 23
Showing results 1 to 25 of 72
Search took 0.06 seconds. Search: Posts Made By: cobralee
Forum: B & B Cobra's --- Speak with Bryan Anderson 10-28-2011, 04:08 PM
Replies: 11
Views: 2,289
Posted By cobralee
Thanks again. Ron

Thanks again.

Ron
Forum: B & B Cobra's --- Speak with Bryan Anderson 10-28-2011, 03:38 PM
Replies: 11
Views: 2,289
Posted By cobralee
Thanks David..I had the same thought last time I...

Thanks David..I had the same thought last time I installed mine but used alot smaller rubber washers....so this time I'll try the heavier duty washers.

Are you using the same type of cooler?

Ron
Forum: B & B Cobra's --- Speak with Bryan Anderson 10-28-2011, 03:11 PM
Replies: 11
Views: 2,289
Posted By cobralee
Oil Cooler Cracking

I'm using B&M's transmission cooler (I think #74235 polished aluminum) to cool my engine oil at the front grill but I get a crack in it about once a year. I'm on my 6th cooler. B&M states they use...
Forum: FE TALK 06-12-2008, 12:38 AM
Replies: 71
Views: 8,065
Posted By cobralee
I have a 427FE in my Cobra running 10:1...

I have a 427FE in my Cobra running 10:1 compression. I've always said that the next time I rebuild, I'm going 11 or 12:1. You can't substitute the power and sound of high compression. If it's not...
Forum: ALL COBRA TALK 03-29-2008, 05:44 PM
Replies: 9
Views: 1,104
Posted By cobralee
Thanks for the input. I did go with the teflon...

Thanks for the input. I did go with the teflon paste instead of tape, with the fear that small pieces of tape could break off into the oil. I'll check tomorrow to see if it leaks.

Thanks again,...
Forum: ALL COBRA TALK 03-29-2008, 02:31 PM
Replies: 9
Views: 1,104
Posted By cobralee
AN Fittings Leaking

It seems to be leaking where the adaptor is going into the pipe threads of the oil cooler.
Forum: ALL COBRA TALK 03-29-2008, 11:11 AM
Replies: 9
Views: 1,104
Posted By cobralee
AN Fittings Leaking

My oil cooler uses AN fittings going into pipe thread fittings. No matter how firm I tighten it, oil still dribbles out. I'm considering using pipe tape or other thread filler or something. Anyone...
Forum: FE TALK 03-21-2008, 11:46 PM
Replies: 51
Views: 6,963
Posted By cobralee
I run a Holley 850cfm on my top oiler for the...

I run a Holley 850cfm on my top oiler for the last 10 years...never had a problem with it. I'd also suggest a Street Demon 850cfm...I ran one of those on another car I had and it ran great.

Ron
Forum: ALL COBRA TALK 03-20-2008, 12:05 AM
Replies: 5
Views: 654
Posted By cobralee
Thanks for the feedback. I've talked to B&M, who...

Thanks for the feedback. I've talked to B&M, who manufactures the cooler and they state they've had these on off road vehicles and have had no problems with the vibrations. They also state that the...
Forum: ALL COBRA TALK 03-18-2008, 10:34 PM
Replies: 5
Views: 654
Posted By cobralee
Oil Cooler Problem

I'm running a B&M trans cooler as an oil cooler (model 74265), bolted to the grill opening. Every 12-18 months, I get a crack in the cooler and lose alot of oil. The only reason I can come up with...
Forum: ALL COBRA TALK 01-21-2008, 08:49 PM
Replies: 1
Views: 442
Posted By cobralee
Alternator Problem

I did a no-no on my FE motor...when jumping the battery, I crossed the cables. The wire to my alternator (int. regulator) burned the cover but I fried the alternator. I got it rebuilt and installed...
Forum: So Cal Cobra Club 10-18-2007, 05:11 PM
Replies: 36
Views: 3,298
Posted By cobralee
Pasadena Cobra Meet

In regards to the LaCanada gathering of cars on Saturday morning, everyone gets there around 7am-7:30am and are gone by 8:30am - 9am. They do have some Cobras there but alot of other cars as...
Forum: ALL COBRA TALK 09-24-2007, 09:58 PM
Replies: 1,195
Views: 312,631
Posted By cobralee
Cool Cobra Tags

My Cobra plate is:

1AWSOM

I have a Chevy race car and those plates are:

AWSOM2
Forum: ALL COBRA TALK 09-04-2007, 03:24 PM
Replies: 25
Views: 2,393
Posted By cobralee
I used a Ferrari red on my Cobra....although I...

I used a Ferrari red on my Cobra....although I learned that there are several versions of a Ferrari Red....it actually came out to be a Toyota Red.
Forum: Arizona Cobra's 04-15-2006, 09:34 PM
Replies: 26
Views: 1,739
Posted By cobralee
I had the same problem...checked fuel filter,...

I had the same problem...checked fuel filter, carburetor, coil, distributor, MSD box....it ended up being the battery....one bad cell affects the MSD box big time.

Good luck.
Forum: Shop Talk 06-11-2005, 11:41 PM
Replies: 20
Views: 2,079
Posted By cobralee
I run a 850cfm Holley on my 427 and have...

I run a 850cfm Holley on my 427 and have absolutely no problems with it. But I've used a Speed Demon on my other car and had no problem with that as well.
Forum: Shop Talk 05-15-2005, 11:51 PM
Replies: 11
Views: 1,230
Posted By cobralee
I have my MSD box mounted under the dash, facing...

I have my MSD box mounted under the dash, facing downward, so not attached to the firewall. It works fine, no heating problems.
Forum: Shop Talk 05-15-2005, 11:48 PM
Replies: 33
Views: 2,674
Posted By cobralee
I run the Triple Flow Radiator from from L.A....

I run the Triple Flow Radiator from from L.A. Radiator. I usually run 180 degrees but when it gets real hot and stop and go traffic, I run 200 tops with my puller fan.
Forum: Shop Talk 04-13-2005, 10:25 PM
Replies: 20
Views: 2,640
Posted By cobralee
I've had the Optima Blue 1000CCA in my cars and...

I've had the Optima Blue 1000CCA in my cars and I'm done wit them! They don't hold charges well at all. You just can't beat the Interstate Batteries for start up after long periods of not running...
Forum: Shop Talk 02-06-2005, 10:28 PM
Replies: 29
Views: 3,401
Posted By cobralee
I added a power booster on and attached it near...

I added a power booster on and attached it near my grill. You can't see it from the front unless you look inside and up. There was no other place I could figure to put it. Also, if some of you...
Forum: Shop Talk 01-22-2005, 11:11 PM
Replies: 19
Views: 2,944
Posted By cobralee
I understand this is a common problem with big...

I understand this is a common problem with big blocks, Ford and Chevy. On my top oiler, I had 1 guage cables and a high torque starter. What solved it was an MSD box that retards at start time. I...
Forum: Shop Talk 01-22-2005, 11:07 PM
Replies: 4
Views: 4,251
Posted By cobralee
Besides checking out the offset and width of the...

Besides checking out the offset and width of the wheel, you might try using a 295x60x15 rather than a 50 series. The 60 series will be a little taller, but not quite as wide.
Forum: Shop Talk 01-22-2005, 10:57 PM
Replies: 22
Views: 2,677
Posted By cobralee
This happened to me a couple of times. I think I...

This happened to me a couple of times. I think I scrapped it off with a thin piece of wood, no scratches since my pipes are jet coated.
Forum: B & B Cobra's --- Speak with Bryan Anderson 01-22-2005, 10:52 PM
Replies: 21
Views: 6,194
Posted By cobralee
Way back when, I bought a used L.A. Exotics...

Way back when, I bought a used L.A. Exotics replica that I had to rebuild from ground up. Bryan Anderson and his staff were most helpful to me during my building stages. They allowed me into their...
Forum: Shop Talk 10-20-2004, 12:00 AM
Replies: 13
Views: 1,631
Posted By cobralee
I have a secret audio in my '65 Comet...

I have a secret audio in my '65 Comet Caliente....and yes, when the battery runs down as the CD changer drains it. Worst yet, I lose my set memory stations on the radio. I also had mine...
Showing results 1 to 25 of 72
Page 1 of 3 1 23

 

All times are GMT -7. The time now is 12:06 PM.

Contact Us - Club Cobra Home - Archive - Top

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink