Thread: Help with Axle loads, CG and mastercylinder sizing
View Single Post
  #1 (permalink)  
Old 01-26-2010, 04:11 AM
Zedn's Avatar
Zedn Zedn is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2009
Location: Sydney, NSW
Cobra Make, Engine: RCM, Jag front and rear, LS3
Posts: 1,640
Not Ranked     
Default Help with Axle loads, CG and mastercylinder sizing
Hi Guys,

I am in the process of calculating my master cylinder sizes and was wondering if anyone can help out with some estimates for static weight of front and rear axles, and approximate height of Centre of Gravity?

I am only looking for estimates as every car is different. I am running jaguar suspension front and rear with an LS3 and 6 speed.

Also can anyone give some recommendations for mastercylinder sizing with Jag brakes (un boosted) and a 6.25:1 pedal ratio with a balance bar set up (wilwood). Any one running this setup?

Thanks,
Liam.
Reply With Quote