Thread: Sidepipes nearly finished
View Single Post
  #7 (permalink)  
Old 05-03-2010, 05:23 AM
Zedn's Avatar
Zedn Zedn is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2009
Location: Sydney, NSW
Cobra Make, Engine: RCM, Jag front and rear, LS3
Posts: 1,640
Not Ranked     
Default
Mike,

The next project on my list is to make a stainless steel fuel tank. I am going to use 1.2mm sheet and i recently purchased a DC pulse tig. I found an old post of yours about this, what size sheet did you end up using and how did it go? pics?

I am going to spend some time practicing with the tig before starting as i have only done mig and arc welding in the past. What sort of tig tip would you recommend for this job?

(sorry for the thread jack)

Liam
Reply With Quote