Thread: Era 3002
View Single Post
  #45 (permalink)  
Old 07-07-2011, 07:59 AM
Jim Holden's Avatar
Jim Holden Jim Holden is offline
CC Member
Visit my Photo Gallery

 
Join Date: Nov 1999
Location: White Plains,, NY
Cobra Make, Engine: ERA140, ERA 267, ERA GT2038, ERA FIA 2045, ERAGT2077 ERA2893000EXP
Posts: 1,117
Not Ranked     
Default
LMH:

Woody is using an "outer lace" wire wheel as opposed to the "inner lace" shown on the original 289 early in this thread.

tkb:

I will ask Woody about the drive train specs. I do know that he is using an early small block, but I don't recall what he is using as trans. In our ERA3001, I installed a TKO with the longer 5th (ie; . 0.64) with a 3.77 rear. Were I to do this setup again, I think I would use the .80 gear.

Jim
Last edited by Jim Holden; 07-07-2011 at 09:21 AM..
Reply With Quote