[bobcowan]

I'v done everything I can think of, and anything anyone else can think of. Instead of getting better, it's only gotten worse.

After rewiring the hall for 12v, changing air gaps, adjusting pots, checking wiring, chanting prayers, and sprinkling it with holy water, I gave up on the Hall sensor. I'm never going to get that to work.

So I reconfigured the board, tossed the Hall, and connected the trigger to the neg side of the coil. Nothing. now there's no trigger at all. Not even a little. Won't run at all.

I'v wasted 5 months and over $1K on this POS. I didn't expect this to be a bolt on project. But I did expect it to actually work. I built a car, this should have been possible. It sure looks pretty, though. Maybe I can sell it as modern art.

Unless I get a better Idea in the next 12 hours or so, I'm going to rip the whole thing out, and put the "old" Haltech back in. I can probably have it up and running again in a week or so.

Maybe next winter I'll take another look at something like BigStuff3