Thread: Clutch slave cylinder rod length ?
View Single Post
  #4 (permalink)  
Old 06-17-2012, 06:28 PM
DanEC's Avatar
DanEC DanEC is offline
CC Member
Visit my Photo Gallery

 
Join Date: Apr 2009
Location: Little Rock area, AR
Cobra Make, Engine: ERA Street Roadster #782 with 459 cu in FE KC engine, toploader, 3.31
Posts: 4,533
Not Ranked     
Default
Chas - yes, it's bolted to the front - loosely. Apparently it bolts to the same hole as the bellhousing and with the bellhousing bolt in I can just get a few threads engagement. I'm going to have to find a longer 7/16 bolt and run through from the bellhousing side and bolt the hyd cylinder to it.

In the manual, ERA shows a spacer to move the cylinder towards the front and maybe I need one of those. They say it's not usually necessary however????
Reply With Quote