Thread: ADR 3/03 seats
View Single Post
  #151 (permalink)  
Old 11-20-2012, 10:41 PM
GTS GTS is offline
CC Member
Visit my Photo Gallery

 
Join Date: Dec 2006
Location: Austin/Manchaca, US
Cobra Make, Engine: poor mans Cobra..Sunbeam Tiger 260
Posts: 5
Send a message via AIM to GTS Send a message via Skype™ to GTS
Not Ranked     
Default
Hi Guys,
Thank you for the drawing and measurements.
Does anyone know exactly how the proceedings are for the ADR approval.Most of our seats are steel tube frames with welded mounting points and in the Fiberglass seats we make big plates that are laminated into the ready made shell for ridgidy.Even if we have adjusters at the side we have an additional steel framing inside that is laminated to the seat back and bottom.How can we have these approved by the ADR ? Again we are in the US and not familiar with the proceedings and in's down under,sorry.
Attached Images
  
Reply With Quote