Not Ranked
I am building a E-M Cobra(96" wheelbase).I am disabled & need the extra room. I have installed a 69 350/300 corvette motor w/a m21 4spd. trans.It has Corvette bucket seats,ss gas tank,vacuum controlled foot box air vents,alum covered firewall & foot boxes(welded). The exhaust runs under the car using 3 chamber flowmaster mufflers, it also has a H pipe to connect both exhaust pipes together.
It has a Must II front end(1 coil cut from the springs) - 9" ford rear(coilovers-180 in/lbs.) Cheers...Don (ST Cloud,FL -407 957-8800)
I have also spent 2 mos. building a hardtop
w/sliding plexiglass windows.
I recently added a 6 speaker stereo w/steering wheel controls.The front spks were placed in the doors & the rear spks were placed in a console between the seats, the tweeters are in the dash. The console also houses 2 cup holders & the fuse panel.
I used a Chevy motor because I love them. I have built approximately 25 cars, each with small block Chev motors.
When I went to college I majored in Mech Engr & dreamed of working for GM, but as faith would have it I ended up working for another Co.(more money & 2 advanced degrees they paid for.) I am now retired & spend most of my time working on my Cobra & helping other car owners w/their cars.I especially enjoy helping Cobra owners(I never charge for helping - It's too much fun)
[This message has been edited by Don Meyer (edited 03-09-2000).]
[This message has been edited by Don Meyer (edited 08-11-2000).]
|