[Dan Case]

Originally Posted by rsk289

If you're talking 289s, the washer jets were a very unusual and rare type. They consisted of a pressed stainless steel plinth, attached with two slotted screws through a thin rubber gasket and a flat stainless baseplate. Between the two was sandwiched a stainless steel washer jet nozzle balljoint, with a knurled head. This has the take-up spout sticking down into the car, through the baseplate. The balljoint could be adjusted to aim the jet. These are seriously hard to find now, and would be a great subject for remanufacture. I do know of another make of car to which they could be sold also!
I have no idea who made them. I don't think it was Trico, more likely a low-volume run by Smiths.

Cobra screen jet = Lucas




There are at least two versions of nozzle but I have found only one on unrestored Cobras.

If purchased in a Lucas "sundries kit" instructions and a little wrench for aiming the spray was included.